Ce produit a déjà été ajouté à Mon Catalogue
Follow this installation guide steps by steps or play the video to watch the installation.
1 - Screw the s union connectors in to your fittings in the wall so that they extend by about 42 mm.
2 - Screw the escutcheons against the wall.
3 - Adjust the spacing so that there is 150 mm between the centres of the escutcheons, and then verify they are level . Adjust if necessary.
4 - Install the mixer and tighten firmly. The nuts must not touch the escutcheons. Adjust if necessary and verify horizontal positioning.
5 - Remove the assembly. Note the depth between the s union connectors and the wall.
Make sure the seal in the hose is in the correct position and then screw the end into the mixer.
1 - Using a thermometer check the water temperature. If it is 38°C when the handle guide lines up with the 38°C marker of the shower body, then no adjustment is needed.
2 - If adjustment is necessary, close the plug-hole and remove the cover on the mixer handle using a small flat-head screwdriver.
3 - Loosen the screw, then remove the handle.
4 - Run the water. Adjust the thermostatic cartridge by turning the notched black element until the temperature reaches 38°C.
Put the handle back with the guide on the handle facing 38°C. Screw in the handle and put the cover back on.